HCBA1402_001.JPG
HCBA1402_001.JPG

Valve Spring Compressor Tool Kit

$235.00

This tool is designed to remove and install the valves of Volvo truck engines.

Compatible with Volvo truck engines D12, D13, D16

Product Specifications /Features :

  1. Place the cylinder head on a flat and clean surface. Make sure that the cylinder head is not scratched when the valves are removed.

  2. Install press tool H.C.B-A1402 in the unit injector hole. Screw the tool in the unit injector retainer screw hole.

  3. Place the tool’s moving part above the valve spring to be removed. Turn down the tool’s “wing nut” until the valve disc has been pressed down and the valve collets can be removed.
    NOTE: Place valves and springs in a marked rack to facilitate reinstallation at the same place in the cylinder head.

  4. Remove remaining valves the same way as above.

  5. Remove the oil seals from the valve guides.

  6. The size for the screw: M10 x P1.5, L: 25mm

Please note that ALL SALES ARE FINAL.

Quantity:
Add To Cart

This tool is designed to remove and install the valves of Volvo truck engines.

Compatible with Volvo truck engines D12, D13, D16

Product Specifications /Features :

  1. Place the cylinder head on a flat and clean surface. Make sure that the cylinder head is not scratched when the valves are removed.

  2. Install press tool H.C.B-A1402 in the unit injector hole. Screw the tool in the unit injector retainer screw hole.

  3. Place the tool’s moving part above the valve spring to be removed. Turn down the tool’s “wing nut” until the valve disc has been pressed down and the valve collets can be removed.
    NOTE: Place valves and springs in a marked rack to facilitate reinstallation at the same place in the cylinder head.

  4. Remove remaining valves the same way as above.

  5. Remove the oil seals from the valve guides.

  6. The size for the screw: M10 x P1.5, L: 25mm

Please note that ALL SALES ARE FINAL.

This tool is designed to remove and install the valves of Volvo truck engines.

Compatible with Volvo truck engines D12, D13, D16

Product Specifications /Features :

  1. Place the cylinder head on a flat and clean surface. Make sure that the cylinder head is not scratched when the valves are removed.

  2. Install press tool H.C.B-A1402 in the unit injector hole. Screw the tool in the unit injector retainer screw hole.

  3. Place the tool’s moving part above the valve spring to be removed. Turn down the tool’s “wing nut” until the valve disc has been pressed down and the valve collets can be removed.
    NOTE: Place valves and springs in a marked rack to facilitate reinstallation at the same place in the cylinder head.

  4. Remove remaining valves the same way as above.

  5. Remove the oil seals from the valve guides.

  6. The size for the screw: M10 x P1.5, L: 25mm

Please note that ALL SALES ARE FINAL.